Filter
Top Products
Operator Manual – PE Series Amplifiers Page - 7
All Rights Reserved Rev 3.1 0506
Typical Applications
The most common
use of a PE-Series
amplifier is a 2-
channel source
driving 2 speaker
channels. In this
illustration, the PE-
Series amplifier is
receiving a signal and
then ‘returns’ it to a
second amplifier
using the provided
connectors. The
amplifier is in
STEREO mode.
Because of their efficient
and high-power design,
PE-Series amplifiers are
well suited to single
channel output to mono
speaker load such as a
subwoofer. This
illustration shows both
PARALLEL and
BRIDGED output
connections using a
single input signal.
Connectors & Polarity
PE-Series amplifiers utilize several different professional audio connectors. The
Euroblock (and Screw-Terminals on models 800 & 1200) connectors are clearly marked
on the amplifier’s rear panel and are straightforward. The connection polarity for the other
three types of connectors (XLR, TRS, and Speakon) are less obvious. The diagrams below
show how each connector should be wired for proper operation. Be sure to read the
Operation section of this manual for important information on the three operating modes.
Important Safety
Instructions – 2
Introduction - 3
The PE Series - 4
Physical Description - 5
Installation – 6
Requirements
Typical Applications
Connectors & Polarity
Operation - 8
Troubleshooting - 9
Spec Table - 10
Measurements - 11
Dimensions - 12
Warranty - 13
Terminals marked
with are
HAZARDOUS LIVE.
External wiring to these
terminals/connectors
requires installation by
trained personnel, or pre-
manufactured cables