Filter
Top Products
9. BATTERY PACK REPLACEMENT
This procedure provides instructions for replacing
the battery pack. Refer to Figure 7 during the proce
-
dure.
1. Install the new battery assembly (9).
2. Replace the battery bracket (8) and insert
the four screws (7) to hold the battery
bracket in place.
3. Reconnect the red/black cable of the battery
pack battery to J6 (6) on the main RF PCB
assembly (3).
4. Set the bottom half in place.
5. While holding the two halves together, turn
the Site Master over and lay it face up on the
work surface.
6. Reinstall the four screws (2).
7. Install the rubber bumpers (1) on all four
corners of the instrument.
10. BATTERY DISPOSAL
The battery used in the Site Master is a recharge
-
able nickel-cadmium (NiCd) battery and is covered
by the Battery Directive (91/157/EEC). As such, the
battery is marked as follows to indicate controlled
disposal.
This marking indicates that
the battery is a recyclable
product.
This marking indicates that
the battery requires separate
collection and shows the
chemical system (Nickel/
Cadmium).
This marking indicates the
heavy-metal component
concentration as a percentage
of battery cell weight.
Spent nickel-cadmium batteries are valuable re-
sources. Because they are reusable, do not throw
them away. Arrange for proper return for recycling
in your locality. If you do not have access to proper
disposal methods, return the battery pack to your
Anritsu service center. Service centers will dispose of
the unit at no charge. Anritsu Service Centers are
listed on page 14 of this manual.
8 Site Master S820A MM
Component
% of Cell
Weight
Nickel 19 to 26%
Cadmium 17 to 22%