Filter
Top Products
2 Ampex 1308903-02
Model No.
Running Head
Unpacking and Inspection ATM 300 Series
1.2 Unpacking and Inspection
Perform the following inspection upon receipt of the unit:
1. Unpack and check the unit for shipping damage. If equipment is damaged notify the
carrier immediately.
2. Check equipment received against the packing list to ensure that the shipment is complete.
If any shortages exist, promptly contact the sales representative.
1.3 Rack Mounting
Ampex ships the ATM as a desk top unit. However, the unit can be mounted into a standard
19-inch (284 mm) rack using the hardware provided. To mount the unit into a rack, install the
two brackets on either side of the unit using the four machine screws provided. Then, mount
the completed assembly to the rack rails.
1.4 Data Connections
The ATM unit provides fiber optic connectors on the front panel and HOTLink connectors on
the rear panel. Figure 2 shows the cable connections. See Table 1 for cable specifications.
Optical Data Cables 62.5/125 µm multimode fiber (ATM 300 and ATM 300M)
8.3/125 µm singlemode fiber (ATM 300S)
Electrical Data Cables Ampex provides the following accessory cable kits:
Ampe
x Part No. Size
1308564-01 120-in (305 cm) - standard
1308565-01 180-in (457 cm)
1308566-01 300-in (762 cm)
1308567-01 600-in (1524 cm)
SyncStart Connector BNC
Power Requirements 100-240 Vac, 47-63 Hz single phase, 150 watt maximum
Dimensions 19” (480 mm) rack mountable
17.0” W x 1.875” H x 8.0” D (432 mm x 48 mm x 203 mm)
Table 1. Specifications (Continued)
Parameter Specification