Filter
Top Products
SET-UP
Some assembly required before you can begin to use your new TTD-2400. Please follow the
assembly instruction below before attempting to use you new turntable.
ASSEMBLY:
Before you begin assembly please be sure all parts and accessories have arrived intact. Please use
the check list below to identify and order parts and accessories.
NOTES:
• Do not connect the AC power plug before assembly has been completed.
• Before turning the power on, make sure once again all the connections and power voltage
settings are correct. Always turn off the power when connecting or disconnecting.
• Read this manual carefully before using the unit. Be sure to store the manual in a safe place for
future reference.
• Attach a stylus cartridge to the
HEADSHELL (7) before assembling the turntable unit.
Headshell Assembly:
When installing a cartridge, refer to the operating instructions of that cartridge. During installation,
attach the stylus protector to guard the stylus tip from damage.
Connect the HEADSHELL (7) lead wires to the cartridge terminals. The terminals of cartridges and the
HEADSHELL (7) lead wires are color coded. Connect each lead wire to the cartridge terminals of the
same color.
White (L+) .............……………...... Left channel +
Blue (L-) ....……………................ Left channel -
Red (R+) ..………….................... Right channel +
Green (R-) .......……………............ Right channel -
Turntable Assembly:
1. REMOVING FROM CARTON:
Carefully remove the main unit with the packing material intact from the box. Remove the packing
material once the unit has been removed from the shipping carton. Be sure to locate all the acces
-
sories located in the packing material.
2. 45 ADAPTER (1):
Locate and remove the 45-rpm adapter from the packing material and place it in the 45 adapter cut
out on the top of the main unit.
3. TURNTABLE PLATTER (20):
Remove the turntable platter from the packing material and gently insert the platter into the CENTER
SPINDLE (3) on the base of the turntable unit.
4. SLIPMAT:
Remove the black slipmat from the packaging and place it on the PLATTER (20)
.
©American Audio® - www.americanaudio.us - TTD-2400™ Instruction Manual Page 7