Filter
Top Products
BASIC OPERATIONS (CONT.)
American Audio® • PRO-DJ2FX™ INSTRUCTION MANUAL • PAGE 21
1) Be sure a disc is inserted in the drive and press the PROGRAM
BUTTON (8). Pressing the PROGRAM BUTTON (8) from any function will
immediately pause the disc and enter the program mode.
2) After activating the program mode the program indicator LED beside the
PROGRAM BUTTON (8) and the PROGRAM INDICATOR (37) in the LCD
(13) will begin to glow indicating Program Mode has been activated.
15. PROGRAM PLAY
This operation allows you to customize your disc playback. You may select specific tracks to played and the
order they will be played in. You may program a maximum of 20 tracks at once and program a single track to
played more than once. To create a program:
Figure 27
3) Select a track to be programmed by using the
FORWARD TRACK SKIP (18) and BACK SKIP
TRACK BUTTON (16).
4) Once you reach the track you wish to place in to the program memory
pressing PROGRAM BUTTON (8) will lock the track into memory.
Figure 29
Figure 28
5) Repeat these steps three and four up to 29 times (up to 30 tracks may be programmed).
6) As you program tracks in memory the LCD (13) will indicate the tracks that have been programmed
in to memory.
7) When you have finished your programming and are ready to begin
playback simply press the PLAY/PAUSE BUTTON (19) and your
program will begin to play.
8) After you have complete your program you can always add more tracks
to your program by repeating the steps one through four. Remember
that you can only a maximum of 30 track in a program and you can
only add track not subtract.
9) To cancel and clear the program press and hold down the PROGRAM
BUTTON (8) for more than two seconds (see figure 29).
Figure 30