Filter
Top Products
This is a momentary function. When the
but ton is depressed the pitch speed will
automatically return to PITCH SLIDER'S (21)
selected pitch. Holding down this button will
give a maximum of -16% pitch. Be sure to
remember that this function is a momentary
pitch adjust-ment, for a more precise adjust-
ment use the PITCH SLIDER'S (21) to
match the BPM’s with another playing music
source.
26. SGL/CTN - This button allows the unit's play
mode to change between Single and Continuous.
In single mode the unit will play a single track
and return to cue mode. In continuous mode the
unit continues to play track by track and returns
to cue mode after all tracks have played. This
function also operates in PROGRAM and FLIP
FLOP modes. In program mode the continuous
function will play all tracks in a program, than
return to cue mode on the first track in the
program. When using two units in Flip-Flop
mode, each unit may be set up to run in either
single or continuous. In single mode a unit will
play a single track and jump to the next unit.
If the next unit is in continuous mode, that unit
will play all tracks and jump back to next unit,
and so on.
27. PITCH BUTTON - This button is used to
turn the pitch function on and off. The pitch
functions of the PITCH SLIDER (21), PITCH
BEND BUTTONS (25) and JOG WHEEL (14) will
not function without this function being activated.
The pitch percentage value can be changed from
(+/- 8%), (+/- 12%) or (+/- 16%). The PITCH
BUTTON’s LED will indicate the maximum pitch
value by flashing red for 8%, glowing green for
12%, or glowing red for 16%.
28.TRANSPORT TRAY - This tray is used to
load and load compact disc. The tray is opened
and closed by pressing the OPEN/CLOSE BUT-
TON (12). Never attempt to force the transport
tray open or closed when the power is turned
off.
29. POWER CONNECTOR - This is the main
power connection. Only use the supplied polar-
ized power cord. Use of any other power may
result in sever damage to the unit. Be sure the
local power matches the unit’s required power.
30. POWER SWITCH - This switch is used to
control the unit's main power.
31. VOLTAGE SELECTOR - Because power
supplies vary from location to location a voltage
selector switch has been incorporated in the
unit's design. This switch can select a voltage
input of 120v or 220v to accommodate the
two major power source. Always be sure to
disconnect the power plug before changing the
voltage.
32. CONTROL - These control jacks are only
used for the "Q" function. Only use these jacks in
conjunction with a compatible "Q" series American
Audio
® mixer or CD unit. Connect the supplied
mini-plug from the CONTROL jack on the rear
of your unit to the control jack on a compatible
mixer or CD unit.
33. DIGITAL OUT - This jack sends a digital
stereo out signal. Use this connection to create
near perfect copies of your disc to a Mini disc,
CD-R, or any other recording device with a digital
input.
34. AUDIO OUT R & L - These jacks send a
left and right analog mono output signal. Use
these jacks to send standard audio to a mixer
or receiver.
GENERAL FUNCTIONS AND CONTROLS (Cont.)
©American Audio® - www.americandj.com - PRO-DJ2FX™ Instruction Manual Page 11