Filter
Top Products
BASIC OPERATIONS (CONT)
American Audio® • DCD-PRO610™ INSTRUCTION MANUAL • PAGE 23
1) Be sure a disc is inserted in the drive then press and hold the
DTA/FX(22) and tap the PRG/HOLD FX BUTTON (13) once.
Pressing the DTA/FX(22) and tapping the PRG/HOLD FX BUTTON
(13) from any function will immediately pause the disc and enter
the program mode.
2) After activating the program mode the PROGRAM INDICATOR
LED(52) in the LCD (14) will begin to glow indicating Program
Mode has been activated.
16. PROGRAM PLAY
This operation allows you to customize your disc playback. You may select specific tracks to played and the
order they will be played in. You may program a maximum of 30 tracks at once and program a single track to
played more than once. To create a program:
Figure 28
3) Select a track to be programmed by using
the FORWARD TRACK SKIP (21) and
BACK SKIP TRACK BUTTON (20).
4) Once you reach the track you wish to place in to the program
memory pressing PRG/HOLD FX (13) will lock the track into
memory.
Figure 30
Figure 29
5) Repeat these steps three and four up to 29 times (up to 30 tracks may be programmed).
6) As you program tracks into memory, the LCD (14) will indicate how many tracks have been programmed.
7) When you have finished programming and are ready to begin
playback simply press the PLAY/PAUSE BUTTON (29) and your
program will begin to play.
8) You can always add more tracks to your program by repeating
steps one through four. Remember that you can only program a
maximum of 30 tracks, and you can only add tracks not subtract
them.
9) To cancel and clear the program press and hold down the DTA/
FX(22) and PRG/HOLD FX (13) for more than two seconds (see
figure 28).
Figure 31