Filter
Top Products
PITCH ADJUSTMENTS
©American Audio® - www.AmericanAudio.us - CDI-300™ Instruction Manual Page 23
2. PITCH BENDING:
Unlike the
PITCH SLIDER (5) adjustment this function will momentarily increase or decrease a tracks speed
during playback. There are two ways to operate this function with the (-) & (+) PITCH BUTTONS (7)
or with the
JOG WHEEL (9)
. The maximum pitch bend percentage allowed is +/- 100%. The pitch bend function will work
in conjunction with the
PITCH SLIDER (5) pitch setting. For example, if the PITCH SLIDER (5) is set to a 2%
pitch gain the pitch bending process will begin at 2% and wi
ll continue to the maximum of +/- 100%.
NOTE: A -100% pitch manipulation will stop playback entirely.
Holding down or tapping on the (+)
PITCH BEND BUTTON
(7) will provide
a speed bump in the playback pitch.
Holding down or tapping on the
(-)
PITCH BEND BUTTON
(7) will provide
a slow down in the playback pitch.
PITCH BEND BUTTONS (7):
The (+) PITCH BEND BUTTON (7) will increase track playback speed and the (-) PITCH BEND BUTTON (7)
will decrease track playback speed. The extent to which the speed changes is proportionate to the amount
of time the button is pressed. For example, if the (+) PITCH BEND BUTTON (7)
is held down continuously as
in figure 36, the disc speed will increases and will continue to increase until it reaches a maximum of 100%
speed gain. When you release the
(+) PITCH BEND BUTTON (7) the disc speed will automatically return to it’s
previous set speed.
Figure 34
Adjusting the PITCH SLIDER'S RANGE (5): You may change the
PITCH SLIDER'S (5) operating range at any time. To change the operating
range be sure the pitch function is turned on, see figure 33.
The pitch per-
centage can be changed between +/-4%, +/-8%, +/-16%, and +/- 100%.
4% will allow the least amount of pitch manipulation and 100% will allow
the most amount of pitch manipulation. To adjust the different ranges,
press the
PITCH ON/OFF BUTTON (3) and tap on the PITCH RANGE BUT-
TON (1) until your desired value is reached, see figure 34.
Figure 36
Figure 35