Filter
Top Products
Power Switch With LED (1)
Turns the apparatus on and off. Press the SW, the power LED inside the SW will turn on.
Dial Control Knob (10)
Used only to change editable values.
3.2 The Rear Panel
Input (19/20)
These are XLR balanced connectors which connect to sources such as the channel inserts of mixing consoles.
They may be used with nominal input levels from consumer to professional audio.
Outputs (21/22)
These are XLR balanced connectors which connect to devices such as the channel inserts on a mixing console
or power amplifier input. For mono applications, use the output1 and/or output2.
MIDI Connectors
MIDI in (23): 5-poles DIN connector for the MIDI input to the CONTROL60.
MIDI thru (24): 5-poles DIN connector for the MIDI thru.
MIDI out (25): 5-poles DIN connector for the MIDI output from the CONTROL60.
Power Connector (26)
This is an IEC 3-pole socket for connecting the AC power supply to the CONTROL60.
4. INSTALLATION & CONNECTION
4.1 Power Up and Audio Connections
a. Audio Connections
b. Power Up Setting
The connections between the CONTROL60 and the other audio devices have to be made using high quality
cables so to prevent bad performances of the CONTROL60 itself. So it should be good to use low-capacitance
shielded cables with a flexible internal conductor. Connect the cables to the CONTROL60 properly by observing
the following precautions:
Do not bundle audio cables with AC power cords.
Do not place audio cables and CONTROL60 near sources of electromagnetic interference such as:
Transformers, monitors, computers, etc.
Always unplug cables by firmly grasping the body of the plug and pulling directly outward.
Do not place cables where they can be stepped on.
Before turning on the CONTROL60's power, check if:
All connections have been made correctly.
The volume controls of the amplifier or mixer are turned down.
Insert the Power plug into the POWER input on the rear panel of the CONTROL60 and plug the power cord into
an AC outlet.
Turn on the power of the CONTROL60, pushing the ON/OFF button on the front panel.
Turn on the power of the amplifier/mixer, and adjust the volume.
13.Up key
14.Right key
15.Down key
16.Left key
17.LCD graphical display 128 64
18.Vu-meter
INPUT1INPUT2
OUTPUT1OUTPUT2
INPUTTHRUOUTPUT
MIDI
AC INPUT
95-240V 60-50Hz
Rated Power Consumption 15W
FUSE:
210-240V: T250mAL 250VAC
95-120V: 500mA 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk