Filter
Top Products
4.3.4 AUX
Press key (the related LED is ON), this screen will present:AUX
Up/Down/Left/Right key: These keys are used to navigate menus.
Enter/Esc key: These keys are used to access or to leave the menus, or to confirm the parameter values.
Graphic display: 128 64 pixel
11
Use to select between Freq, Order relative to HP and LP (Butter worth).
Dial changes selected values, while updating the graphics, the asterisk will be shown as above. The filter
will be inserted into the signal path in real time (no confirmation needed).
UP/DOWN/LEFT/RIGHT
Use to select between Delay Adjust, Delay Fine, Output Volumes and Input Gain.UP/DOWN/LEFT/RIGHT
Dial changes selected values, no confirmation is needed.
When finished editing the EQ preset, if desired the result can be saved with the STORE function; otherwise
whatever preset loading will overwrite all the parameters. In the same way when the EQ is switched off all
unsaved data will be lost. If the system is switched off while in bypass mode, when switched on again it will
start in bypass mode. In this mode all the keys are disabled until the user presses again the keyBYPASS
restoring the system to normal operation.
Bypass key: Using this key is possible to bypass the process, sending to the CONTROL60 outputs exactly
the input signals. this is a digital bypass and the input signal is anyway converted digitally before to be sent
to the outputs. When the CONTROL60 is in this mode (bypass LED will on), all the keys except the BYPASS
key are disabled.
Edit key: This key allows the user to enter the EDIT menu (the Edit LED will be On).
When entered the edit menu, the user will be able to access and modify all the parameters related to the
process. When the user modifies one parameter value, the LED starts to blink to signal the update. The LED
will blink until the storing of the new modified preset in one of the 64 available locations.
Flat key: By means of this key it is possible to reset all the parametric filters, i.e. Set all the gains to 0dB.
This key works only when the edit LED is lit. When entering into EDIT EQ , flat key should be used to set all
the gains to 0dB.
Channel key: Selects the channel to be edited if the EQ type is dual mono; the channels are indicated by
different LED colors.
Vu-meter key: This function allows the user to set visualization of input (LED OFF) or output (LED ON)
signal on the LED bar-graphs.