Filter
Top Products
MULTI-TASKER
10
10
Send commands [SEL2C5] [+] [+] [+] [+] [+].
After executing that command, send [C5] to get
the new status of card 5:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:12
BASS:8
TREBLE:14
LOUDNESS:ON
[SELmGkUi]
This command sets path to adjust the individual
volume level for a group of cards. Command
Format: [SELmGkUi] [–] [–] [–] [–] or [+] [+] [+]
[+]
m = Input number (m = 1 to 3)
k = group number (k = # from 1-9)
i = Unit ID number (i = 0 to 9)
+ = increases volume. (maximum of 15 levels
for audio).
– = decreases volume. (maximum of 15 levels
for audio).
Example:
If card 1, 2, and 3 are grouped as group 5 of
unit 1, send the [SEL1G5U1] [–] [–] [–]
command to decrease the volume for card 1, 2,
and 3 simultaneously.
5. [SLOCnUi]
This command sets path to adjust the output
volume level for single card. Command Format:
[SLOCnUi] [–] [–] [–] [–] or [+] [+] [+] [+]
n = Card ID number (n = slot # from 1 to 19)
i = Unit ID number (i = 0 to 9)
+ = increases volume. (maximum of 15 levels
for audio).
– = decreases volume. (maximum of 15 levels
for audio).
Example:
If the status of audio card 5 of unit zero is as
follows:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:12
BASS:8
TREBLE:14
LOUDNESS:ON
Send commands [SLOC5] [+] [+] [+] [+] [+].
After executing that command, send [C5] to get
the new status of card 5:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:17
BASS:8
TREBLE:14
LOUDNESS:ON
6. [VOLmAyCnUi]
This command sets absolute individual volume
level for single card. Command Format:
[VOLmAyCnUi]
m = Input number (m = 1 to 3)
y = Absolute audio level (y = 1 to 32)
n = Card ID number (n = slot # from 1 to 19)
i = Unit ID number (i = 0 to 9)
Example:
If the status of audio card 2 of unit zero is as
follows:
VOLIN1:16
VOLIN2:21
VOLIN3:32
VOLOUT:17
BASS:8
TREBLE:14
LOUDNESS:ON
Send commands [VOL1A2CnUi],
[VOL2A12CnUi], [VOL3A18CnUi]. After
executing the above commands, send [C2] to
get the new status of card 2:
VOLIN1:2
VOLIN2:12
VOLIN3:18
VOLOUT:17
BASS:8
TREBLE:14
LOUDNESS:ON
[VOLmAyGkUi]
This command sets absolute individual volume
level for a group of cards. Command Format:
[VOLmAyGkUi]
m = Input number (m = 1 to 3)