Filter
Top Products
38-EN
• The selected channel is not functional.
- Change channels.
• The user has selected a channel number that does not exist or is
not subscribed to.
- The unit will revert back to the previously selected channel.
• There is no artist name/feature, song/program title, or additional
information associated with the channel at that time.
- No action needed.
• If an error or other problem occurs.
- Change channels or consult your Alpine dealer.
• Communication error
- Turn the ignition key off, and then set to ON again.
• Abnormal current is run to the USB connector device.
- You can solve the problem by switching the source, turning the
unit power off, or ACC to the OFF position.
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
• A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
• The iPhone/iPod is not connected.
- Make sure the iPhone/iPod is correctly connected (refer to
“Connections” on page 43).
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
- Download songs to the iPhone/iPod and connect to this unit.
• Communication error
- Turn the ignition key off, and then set to ON again.
- Check the display by reconnecting between the iPhone/iPod
and this unit, using the iPod cable.
• Caused by the iPhone/iPod Software Version not being
compatible with this unit.
- Update the iPhone/iPod Software Version to be compatible
with this unit.
• The iPhone/iPod is not verified.
- Change another iPhone/iPod.
• Abnormal current is run to the USB connector device.
- You can solve the problem by switching the source, turning the
unit power off, or ACC to the OFF position.
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
• Malfunction occurred as a result of the speaker cable shorting on
the car chassis.
- Route the cable correctly, and set POWER IC to ON (page 17).
If the above solution does not work, consult your nearest
dealer.
Indication for USB memory
NO FILE
Indication for iPod Mode
Indication for all Modes
(XM mode)