Filter
Top Products
- Page 31 -
21 TAPE
The TAPE button is used to access the tape interface features of the MMT-8. This allows the user to save
and retrieve sequence data with an ordinary cassette recorder. Pressing and holding the TAPE button
results in the following display:
Pressing the RECORD button initiates the save to tape. Both buttons can now be released, since this
operation may take over two minutes, during which the display will read:
The display shows the current part or song being output. This display will advance until all data is output.
Pressing the STOP/CONTINUE button will abort the operation. Before pressing RECORD, the page up and
page down buttons can be used to access the other five tape pages. They are as follows:
In all five of these pages, pressing RECORD initiates the operation. The verify function is used to ensure
that the data just recorded to tape is good. LOAD ALL PARTS & SONGS FROM TAPE loads the entire
sequence memory with the data on tape. LOAD ONE PART FROM TAPE and LOAD ONE SONG FROM
TAPE allow a single part or song to be loaded from a tape. The keypad can be used to select the desired
number. For operations involving output to tape, after pressing RECORD the display will change to the
following:
When the initial tone on the tape is detected, the display shows (depending on the page shown when
RECORD was pressed):