Filter
Top Products
19
En
To record a 4-second blank space (only for TUNER
or AUX source)
Inserting 4-second blank spaces may help you locate the
beginning of the track on other equipment with the "Music
Sensor" function.
1Press dTAPE (REC MUTING) on the unit during
recording or in recording pause mode.
"REC MUTING" flashes in the display for 4 seconds (a
blank space is added) and then the unit enters recording
pause mode.
2Press REC START/REC PAUSE to resume recording.
To record a blank space shorter than 4 seconds, press
dTAPE (REC MUTING) again while "REC MUTING"
flashes.
To record a blank space longer than 4 seconds, press
dTAPE (REC MUTING) again after the unit enters
recording pause mode.
Each time the button is pressed, a 4-second blank space is
added.
To erase a tape
1 Insert the tape. Set the tape to the desired point if needed.
2 Press AUX.
If optional equipment is connected to the AUX IN jacks, turn
it off.
3Press REC START/REC PAUSE twice.
Edited CD recording
AI Edit Recording
Preparation
Prepare a tape that is longer than the CD length.
When recording a whole CD, AI Edit Recording takes the length
of your tape into account and rearranges the recording order of
the tracks if necessary, so that no track is cut short at the end
of the side.
(AI: Artificial Intelligence)
•Recording cannot start from a point halfway in the tape.
•AI Edit Recording cannot be used with MP3-CDs.
•AI Edit Recording cannot be used with discs containing more
than 30 tracks.
1
Insert the recordable tape.
2
Press FUNCTION on the remote to select the CD
function, and load disc(s).
3
Hold down SHIFT and press CD EDIT/CHECK on
the remote in stop mode.
"AI EDIT" and "AI C--00" is displayed.
4
Press the desired CD slot buttons (1-5) to select
a disc.
When using the remote, press DISC SELECT then press
the numbered button (1-5) within 6 seconds.
5
Press the numbered buttons on the remote to
enter the length of the recordable tape.
10 to 99 minutes can be specified.
- For a 60-minute tape press 6 and 10/0.
In a few seconds, the unit determines the tracks to be
recorded for each side.
•f or g can also be used to specify tape length.
6
Press REC START/REC PAUSE once to start
recording.
The tape is rewound to the beginning of the side facing
out from the unit, "REC MUTING" flashes on the
display and the lead segment is played through for 10
seconds, and recording starts.
When recording on the side facing out from the unit (side
A) finishes, recording on the opposite side (side B) starts.