Aiwa XR-MN5 Home Theater System User Manual


 
22
En
Timer recording
Timer recording is available only for TUNER sources.
1
Prepare the recording destination.
Insert the recordable tape in tape deck.
2
Hold down SHIFT and press REV MODE on the
remote to select a reverse mode.
To record on one side only, select p.
To record on both sides, select [.
If selecting "]" mode in this step, the reverse mode
changes to "[" when starting recording.
3
Hold down SHIFT and press TIMER on the remote
repeatedly so that "5" and "TIMER REC" are
displayed.
4
Within 6 seconds, press ENTER.
"ON TIME" is displayed.
5
Press f or g to set the timer start hour,
and press ENTER.
6
Press f or g to set the minute, and press
ENTER.
"OFF TIME" is displayed.
7
Set the time to stop playback following the same
procedure as steps 5 and 6.
8
Select the band and tune in the desired station.
9
Insert a recordable tape and then turn the unit
off.
"5" remains in the display to indicate the timer standby
mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and records the selected
source. After the specified timer-activated duration, the
unit turns off again.
•To stop timer setting in steps 3 to 6, press CLEAR.
Timer standby mode is also cancelled.
The timer recording is not activated when the clock is not
set. ("SET NG" is displayed.)
•The timer recording will not begin unless the unit is turned
off first.
To check the timer setting
Hold down SHIFT and press TIMER on the remote repeatedly
so that "TIMER PLAY" or "TIMER REC" appears in the
display.
The timer-on time, the time to stop playback and the source
are displayed for 6 seconds.
To change the timer setting
Reset the timer again.
To cancel the timer
Hold down SHIFT and press TIMER on the remote repeatedly
until "TIMER OFF" is displayed. "5" and "TIMER REC"
disappear from the display.
Tip:
Your timer setting is retained even if the timer is cancelled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.
Notes
The timer playback performs every day at the specified time
unless you cancel it.
•You cannot set the same time for timer-on time and timer-
off time. "SET NG" is displayed if you do that. In this
case, reset the time.
The timer playback will not begin unless the unit is turned
off first.