Filter
Top Products
BEFORE OPERATION
SETTING THE CLOCK
l=
__-.
r-
POWER ~f=
o
~
i
,==+—-“”’!====4
[p
mj
-107–-
—.
-.,
k~A
\_____
—!
To turn the unit on
@
SHIFT
FUNCTION
Press one (ofthe function buttons (TAPE, TUNER, VIDEO/AUX,
CD)-The unit is turned on.
At this time, playback of the inserted disc begins, or the previously
tuned station is received (Direct Play Function).
The POWER button is also available to turn the unit on.
The disc compartment may open and close to reset the unit,
when the unit is turned on.
After use
Press the POWER button to turn off the power. The display
changes to the clock.
DEMO (Demonstration) mode
When the AC cord is connected for the first time, the display
window demonstrates the functions of the unit. When the power
is turned on, the DEMO display is overridden by the operation
display.
To cancel DEMO mode
Press the II SET button while the power is off. In this time, the
clock on the display flashes. Go to step 2 of the SETTING THE
CLOCK to set the clock,
To use the SHIFT button on the remote control
Buttons @ have two different functions. One of these functions
is indicated on the button, and the other on the plate above the
button.
To use the function on the button, simply press the button.
To use the function on the plate above the button, press the
button while pressing the SHIFT button.
To use the FUNCTION button on the remote control
The FUNCTION button substitutes for the function buttons
(TAPE/DE(;K 1/2, TUNER, VIDEO/AUX,CD) on the main unit.
Each time the FUNCTION button is pressed, the next function is
selected cyclically.
● If the unii. is not going to be used for an extended period of
time, remove the batteries from the remote control to prevent
possible electrolyte leakage.
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (television, etc.)
Set the time as follows while the power is off.
1
2
3
4
5
Press the II SET button.
The hour flashes.
CLOCK
SHIFT
Press the
l<< DOWN or FFI UP button to
designate the hour.
Press the II SET button to set the hour.
The hour stops flashing and the minute starts flashing,
Press the l<< DOWN or FM UP button to
❑
designate the minute.
Press the 11 SET button to set the minute and
complete setting.
The minute stops flashing on the display and the clock starts
from 00 second,
To
correct the current time
Press the POWER button to turn the unit off. Press the II SET
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The clock is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on
the remote control and then press the
■ button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted, all settings stored in memory after
purchase may need to be reset.
ENGLISH ~