Filter
Top Products
8
ENGLISH
MANUAL TUNING
POWER
MODE
BAND
f,g
1
2
1
Press TUNER/BAND repeatedly to select the
desired band.
AMFM
If TUNER/BAND is pressed while the power is turned off, the
previously tuned station will be played (Direct Play Function).
When using the remote control, press BAND repeatedly while
the power is on.
2
Press f or g to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed.
During FM stereo reception, “STEREO” is displayed.
STEREO
To search for a station quickly (Auto Search)
Keep f or g pressed until the tuner starts searching for a
station. After tuning in a station, the search stops.
To stop the Auto Search manually, press f or g.
• The Auto Search may not stop at stations with very weak signals.
RADIO
RECEPTION
When an FM stereo broadcast contains noise
Press MODE on the remote control so that “MONO” lights up on
the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, press MODE again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press POWER while pressing TUNER/BAND while the power is
on.
To reset the interval, repeat this procedure.
NOTE
When the AM tuning interval is changed, all preset stations are
cleared. The preset stations have to be set again.