Aiwa LCX-357 Stereo System User Manual


 
En
ENGLISH
13
TAPE
PLAYBACK
BASIC RECORDING
s
s
a
a
3
4
1
2
Preparation
Set the tape to the point where recording will start.
Only Type I (normal) tapes can be recorded.
1
Insert the tape to be recorded on into the deck.
Insert the tape with the side to be recorded on first facing out
from the unit and the exposed side down.
2
Press TAPE/REV MODE to select the reverse
mode.
To record on one side only, select p.
To record on both sides, select [ or ].
3
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press CD and load the disc.
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
To record from the connected equipment, press AUX and
prepare to play.
RECORDING
RECORDING
4
Press w to start recording.
When the selected source is CD, play and recording start
simultaneously.
When the selected source is connected equipment, start playback
on the source.
To stop recording, press s.
To pause recording, press a. (Applicable when the source is
the radio or connected equipment.) To resume recording, press
again.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces may help you to locate the
beginning of the track on other equipment. (Applicable when the
source is the radio or connected equipment.)
1 Press w during recording or while in recording pause mode.
4 flashes for 4 seconds and the tape runs without
recording. After 4 seconds, the deck enters the recording
pause mode.
2 Press a to resume recording.
To insert a blank space of less than 4 seconds, press w
again while 4 is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters recording pause mode, press w again. Each time the
button is pressed, a 4-second blank space is added.
To erase a recording
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing TAPE/REV MODE.
4 Press AUX.
If optional equipment is connected to the AUX jacks, turn it
off.
5 Press w to start the erasure.