Filter
Top Products
MANUAL TUNING
PRESETTING STATIONS
1
2
TUNER
MODE
Press the BAND button repeatedly to select the
desired band.
m
Press the W or M button to select a station.
Each time the button is pressed, the frequency changes.
When a station is tuned in, “TUNE” is displayed for a moment.
During FM stereo reception, “STEREO” is displayed.
To play a tuned station when
the power is off (Direct
Play Function)
Press the BAND button. The power is turned on and the tuned
stations is played.
To search for a station quickly (Auto Search)
Keep the 14 or FPI button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the W or - button.
● The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the TUNER MODE button on the remote control.
“MONO” appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the BAND button.
To reset the interval, repeat this procedure.
When the AM tuning interval is changed, all preset stations (see
“PRESETTING STATIONS”) are cleared. The preset stations
have to be set again.
‘——————l
P-SCAN
0–9,+1 o
The unit can store a total of 32 preset stations. When a station
is stored, a preset number is assigned to the station. Use the
preset number to tune into a preset station directly.
1
2
3
Press the BAND button to select a band. Then,
press the l++ or >>1 button to select a station.
Press the SET button to store the station.
A station is assigned a preset number, beginning from 1 in
consecutive order for each band.
m Frequency
Preset number
Repeat steps 1 and 2.
Each band can only store a maximum of 16 preset stations.
To listen to preset stations
Use the remote control to select the preset number directly.
1 Press the BAND button to select a band.
2 Press the numbered buttons to select a preset number.
Example:
To select preset number 15, press the +1 Oand 5 buttons.
To select preset number 10, press the +1 Oand Obuttons.
When operating on the main unit, press the
■ button
repeatedly.
Each time the button is pressed, the next higher number is
selected.
To clear
a preset station
Select the preset number of the station to be cleared. Then, press
the SET button, and press the Fll button within 4 seconds while
the frequency flashes.
The preset numbers of all other stations in the band with higher
numbers are also decreased by one.
To scan preset stations
Press the P-SCAN button on the remote control until “P.SCAN”’
is displayed. The preset stations are received in order for 5
seconds each. The preset number flashes during reception.
To stop scanning, press the VOLUME button.
7 ENGLISH