Filter
Top Products
CONNECTIONS
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is
120 V AC, Check that the rated voltage matches your local
voltage.
IMPORTANT
● Connect the speakers, antennas, and all optional equipment
first. Then connect the AC cord in the end.
● There are no differences between the front speakers. Both
speakers can be connected as L (Left) or R (Right).
1
Connect the speaker cords to the main unit.
The cords with the white stripes should be connected to the
~ terminals and the other cords to the O terminals.
2
Connect the supplied antennas.
Connect the FM antenna to the upper one of the FM ;75 Q
terminals and the AM antenna to the AM LOOP terminals.
II
FM antenna
AM
antenna
3 Connect the AC cord to an AC outlet.
To position the antennas
FM antenna:
Extend this antenna and change the direction and angle to find
the best reception.
AM antenna:
Position to find the best direction.
m
● Do not leave objects generating magnetism near the speakers.
● Do not bring the FM antenna near metal objects or curtalln rails.
m
● Do not bring the AM antenna near other optional equip m~ent,
the stereo system itself, the AC cord or speaker cords, since
Do not short-circuit the 0 and
O
noise will be picked up.
speaker cord leads; otherwise the
“ Do not unwind the AM antenna wire.
sound may become inaudible. If
this happens, disconnect the AC
cord from the AC outlet and re-
To connect other optional equipment+ page 11.
connect the speaker cord
3
correctly. Connect then the AC
cord and turn the unit on again.
antenna
3 ENGLISH