Filter
Top Products
22
GB
You can record a preset radio station from a
specified time.
To timer record, you must first preset the radio
station (see “Presetting radio stations” on
page 14) and set the clock (see “Setting the
clock” on page 9).
Use buttons on the remote for the operation.
1 Tune in the preset radio station (see
“Listening to a preset station” on
page 15).
2 Press CLOCK/TIMER SET.
3 Press . or > repeatedly until
“REC SET?” appears, then press
ENTER.
“ON TIME” appears and the hour
indication flashes.
4 Set the time to start recording.
Press . or > repeatedly to set the
hour, then press ENTER.
The minute indication flashes.
Press . or > repeatedly to set the
minute, then press ENTER.
5 Set the time to stop recording following
the same procedure as step 4.
Rec Timer settings and the desired station
appear, then the original display returns.
6 Load a recordable tape.
7 Press TAPE nN on the unit
repeatedly to select recording side.
If you select both sides recording or front
side recording, press TAPE nN on the
unit to light up the N indicator. If you
record on the reverse side, press TAPE
nN on the unit again to light up the n
indicator.
8 Press x.
9 Press DIRECTION on the unit
repeatedly until g appears to record
on one side or h (or j) to record on
both sides.
10Press ?/1 to turn off the system.
Other operations
Notes
• You cannot activate the Play Timer and Rec Timer at
the same time.
• If you use the Rec Timer and the Sleep Timer at the
same time, the Sleep Timer has priority.
• Do not operate the system from the time the system
turns on until the recording starts (about 15 seconds
before the preset time).
• If the system is on about 15 seconds before the preset
time, the Rec Timer will not be activated.
• The volume is reduced to minimum during
recording.
• Note that if the Rec Timer is set at the same time as
the Play Timer sound source is set to tape, the Rec
Timer sound may be recorded onto the tape.
Timer recording radio
programs
—Rec Timer
To Do this
Activate the timer/
check the setting
1 Press CLOCK/TIMER
SELECT.
2 Press . or >
repeatedly until “SELECT
REC SEL?” appears, then
press ENTER.
Change the setting Start over from step 1.
Cancel the timer
1 Press CLOCK/TIMER
SELECT.
2 Press . or >
repeatedly until “SELECT
TIMER OFF?” appears, then
press ENTER.