Filter
Top Products
Tuner
15
GB
Other operations
To improve tuner reception
When tuner reception is poor, set CD player
power off by CD power manage function.
CD power is factory set to on.
1 Press FUNCTION repeatedly to switch the
function to CD.
2 Press ?/1 to turn off the system.
3 Press ?/1 while holding x on the unit.
“CD POWER OFF” appears.
To set CD power on
Repeat the procedure above and “CD POWER
ON” appears.
Notes
• When “CD POWER OFF” is selected, disc access
time is increased.
• You cannot change the setting in Power Saving
Mode.
To change the AM tuning interval
(except for European models)
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding M,
press ?/1 on the unit. When you change the
interval, all the AM preset stations are erased.
To reset the interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in Power
Saving Mode.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power failure
occurs.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first
(see “Presetting radio stations” on page 14).
1 Press TUNER BAND (or FUNCTION
repeatedly) to switch the function to
tuner.
2 Press TUNER BAND repeatedly to
select “FM” or “AM”.
3 Press TUNING MODE repeatedly until
“PRESET” appears in the display.
4 Press – or + (or TUNING – or + on the
unit) repeatedly to select the desired
preset station.
Listening to non-preset radio
station
— Manual Tuning
1 Press TUNER BAND (or FUNCTION
repeatedly) to switch the function to
tuner.
2 Press TUNER BAND repeatedly to
select “FM” or “AM”.
3 Press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear from
the display.
4 Press – or + (or TUNING – or + on the
unit) repeatedly to tune in the desired
station.
Note
When tuner function is selected as the current function
and CD is pressed to select CD during “CD POWER
OFF”, it may take some time to switch the function
(page 15).
To Do this
Tune in a station
with a weak signal
Follow the procedure described
in “Manual tuning preset”
(page 14).
Set another station
to the existing
preset number
Start over from step 2. After
step 5, press – or + (or
TUNING – or + on the unit)
repeatedly to select the preset
number you want to store the
station.
Listening to the radio
continued