Filter
Top Products
CONNECTING SPEAKERS @
Speaker terminals
Connect front speakers (system A and/or B), a center speaker
and surround speakers to the corresponding speaker terminals
on the unit:
- the front speaker cords to the FRONT SPEAKERS terminals
- the center speaker cord to the CENTER SPEAKER terminals
- the surround speaker cords to the SURROUND SPEAKERS
terminals.
For more powerful bass, connect a sub woofer with a built-in
amplifier to the SUPER WOOFER d jack.
Speaker impedance
● Front and center speakers
The SPEAKER IMPEDANCE SELECTOR on the rear should be
set to the position that matches the impedance value of the front
and center speakers.
When using 4 ohm speakers, set the selector to 4Q. When using
8 ohm speakers, set the selector to 8Q. Please unplug the AC
cord before setting the selector.
● Surround speakers and super woofer
The SPEAKER IMPEDANCE SELECTOR has no effect on the
SURROUND SPEAKERS terminals and the SUPER WOOFER
~ jack. Forthe surround speakers and sub woofer, use speakers
of 8 ohms or more.
Connecting + to +, -to - terminals
To get the proper sound effect, the speaker terminals on the unit
and the speaker should be connected with proper polarity; the +
terminal on the unit should be connected to the + terminal on
the speaker (and – to –).
m
● Be sure to connect the speaker cords correctly as shown in
the illustration on the right column. Improper connections can
cause shorl circuits in the SPEAKER(S) terminals.
● Do not leave objects generating magnetism near the speakers.
● When using a sub woofer, select the speaker system A (see
page 6). Otherwise no sound can be heard from it.
POSITIONING THE SPEAKERS
Position the speakers to make the most of the Dolby Pro Logic
or DSP effect (see “DOLBY PRO LOGIC).
@ Front speakers
@ Center speaker
Position in the center of the two front speakers. In addition,
position on or below the TV set, if connecting a TV set to the
unit.
@ Surround speakers
Place the surround speakers directly to the side of or slightly
behind the listening area. Align them horizontally, about 1
meter (3.2 feet) above ear height.
m
● Sound is heard from the surround speakers when the DSP is
set to on.
● Sound is heard from the center speaker mainly when the Dolby
Pro Logic is set to on. Note that when you select the PHANTOM
mode of the Dolby Pro Logic, the center speaker is muted.
(For details, see “DOLBY PRO LOGIC”).
Front smeakers
Lift up the terminal flap,
insert the speaker cord lead
into the terminal slot, then
close the flap. Check that the
cord is connected securely.
Center speaker
SPEAKER
IMPEDANCE
SELECTOR
—
L
!,;
9\
Sub woofer
Surround speakers
I
/-----
I
1I ‘-
—..—.———..—-
)
—.—-—
5
.. —.—.—
.) L..___’_”___,,.
——.——
ENGLISH
4