Filter
Top Products
1
2
3
.. —.+
k
4
2,3
Press CLOCWTIMER m, then press II SET
within 4 seconds.
Press - DOWN or - UP to designate
hour, then press II SET.
The hour stops flashing and the minute starts flashing.
Press + DOWN or - UP to designate
minute, then press 11 SET.
the
the
The minute stops flashing on the display and the clock starts
from 00 seconds.
To disdav the current time
Press CLOCK. The time is displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK and then press
■ within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
The unit can be turned off automatically at a specified time.
Use the remote control.
1
Press SLEEP.
2 Within 4 seconds, press + or FF to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
Specified time
To check the time remaining until the power is turned off
Press SLEEP once. The remaining time is displayed for 4
seconds.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
To cancel the sleep timer
Press SLEEP twice so that ‘(SLEEP OFF appears on the display.
* MULTI JOG is also available instead of 44 and W.
‘ MULTI JOG is also available instead of 44 and*.
‘ ENTER is also available instead of II SET.
23 ENGLISH