Aiwa AV-D30 Stereo System User Manual


 
General
TROUBLESHOOTING GUIDE
Power requirements 120 V AC, 60 Hz
Power consumption 125W
Dimensions
430 x 155 x 351
mm
(W XHXD) (17 x 6’/8 x 137/8 in.) If the unit fails to perform as described in these Operating
Weight
10.0 kg (22 lb 1 OZ.)
Instructions, check the following guide.
Specifications and external appearance are subject to change
without notice.
DOLBY PRO LOGIC
Manufactured under license from Dolby Laboratories Licensing
Corporation.
“DOLBY” the double-D symbol DU and “PRO LOGIC” are
trademarks of Dolby Laboratories Licensing Corporation.
GENERAL
There is no sound.
Isthe AC cord connected properly?
Is there an incorrectconnection? (+ page 3)
There may be a short circuitin the speaker terminals.
~ Disconnect the AC cord, then correct the speaker
connections.
Was an incorrectfunction button pressed?
Are the FRONT SPEAKERS A and B buttons set correctly?
(+ page 6)
Sound is emitted from one speaker only.
is the BALANCE set appropriately?
Is the other speaker disconnected?
Sound is heard at a very low volume.
Has the MUTING button been pressed?
An erroneous display or a malfunction occurs.
+ Reset the unit as stated below.
TUNER SECTION
There is constant, wave-like static.
Is the antenna connected properly? (~ page 5)
Is the FM signal weak?
* Connect an outdoor antenna.
\
The reception contains noise interference or the sound is
distorted.
Isthe system pickingup external noiseor multipathdistortion?
+ Change the orientation of the antenna.
~ Move the unitaway from other electrical appliances.
.
To reset
If an unusual condition in the display windo”wor malfunction
occurs, reset the unit as follows.
1 Press the POWER buttonto turn offthe power,
2 Press the POWER button while pressing the
SET button.
Everything stored in memory after purchase is canceled.
[f the power cannot be turned off in step 1 because of a
malfunction, reset by disconnecting the AC cord and carry out
step 2.