Filter
Top Products
~
‘CONNECTING OPTIONAL .’
[
I
EQUIPMENT
1 “
I
CD DIGITAL OUT
(OPTICAL) ~
VIDEO/AUX
MD
LINE OUT
SUPER
WOOFER
Refer to the operating instructions of the connected equipment
for details.
● The connecting cords are ,not supplied. Obtain the necessary
connecting cords.
● Consult your local Aiwa dealer for optional equipment,
VIDEO/AUX, MD JACKS
This unit can input analog sound signals through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
(turntables, LD players, MD players, VCRs, TV, etc.).
Connect the red plug to the R iack, and the white zduato the L
When connecting a turntable
Use an Aiwa turntable equipped with a built-in equalizer amplifier.
LINE OUT JACKS
This unit can output analog sound signal through these jacks.
Use a cable with RCA phono plugs to connect audio equipment
w“ithLINE IN (analog input) jacks.
m
Do not connect an equipment to the LINE OUT terminals and
VI DEO/AUX terminals simultaneously. Otherwise, noise is
generated and malfunction occurs.
CD DIGITAL OUT (OPTICAL) JACK
This unit can output CD digital sound signals through this jack.
Use an optical cable to connect digital audio equipment (digital
amplifier, DAT deck, MD recorder, etc.).
Remove the dust cap @ from the CD DIGITAL OUT (OPTICAL)
jack. Then, connect an optical cable plug to the CD DIGITAL
OUT (OPTICAL) jack.
‘-q?
.9*9W
When the CD DIGITAL, OUT (OPTICAL) jack is not being
used
Attach the supplied dust cap.
SUPER WOOFER 4JACK
Connect an optional powered sub woofer with a built-in-amplifier
to’the jack.
23 ENGLISH
LISTENING TO EXTERNAL
SOURCES
,.—._
1
To play equipment connected to the VIDEO/AUX jacks or MD
jacks, proceed as follows.
1
Press the VIDEOIAUX or MD button.
When a equipment connected to the ViDEO/AUX jacks is
played: press the VIDEO/AUX button.
When a equipment connected to the MD jacks is played:
press the MD button.
2 Play the connected equipment.
To change
a source name in the display
When the VIDEO/AUX button is pressed, VIDEO is displayed
initially. It can be changed to AUX or TV.
With the power on, press the POWER button while pressing the
VIDEO/AUX button.
Repeat the procedure to select one of the names:
To adjust the sound level of the external source
When the sound level of the external source is much higher or
much lower than that of other function sources, adjust it as
follows.
1 Press the VIDEO/AUX or MD button and play the equipment. \
2 Presss the+ or F+ button so that the sound level becomes
the same as that of other function sources.
m“”
During recording, the sound level can not be adjusted.
.
*..