Filter
Top Products
MICROPHONE MIXING
KE
3,4,5
2
. .
Two microphones (not supplied) can be connected to this unit,
allowing you to sing along to music sources.
USe microphones with mini plugs (03.5 mm,
1/8 inch).
1 Connect your microphones to the MIC 1 and MIC
2 jacks.
MIC 1
2 Press one of the function buttons to select the
source to be mixed, and play the source.
3 Adjust the volume and tone of the source.
4 Press the MIC button and turn the VOLUME
control within 4 seconds to adjust the
microphone volume.
The microphone volume can be selected from 1 to MAX (7)
or OFF (cancel).
The volume of both microphones is adjusted simultaneously.
5 Press the ECHO button and turn” the VOLUME
control within 4 seconds to adjust
the echo level.
The echo level can be selected from 1 to MAX (7) or OFF
(cancel).
To change the delay tim’e of echo
Hold down the ECHO button during the echo is on.
“L” (Long) and “M” (Middle) are displayed alternately. At the
desired position, release the button.
To record microphone sound mixed ‘with source sound
Follow the procedure ‘for recording from the sound source (see
page 15).
The SYNC DUB button cannot be used for
mlXlf19 recording.
When not using the microphones
Set the microphone volume and echo level to OFF and remove
the microphones from the MIC jacks.
● Whep the MIC or ECHO level is changed, the SURROUND
mode is automatically canceled.
. If a microphone
is held too n-earthe speakers, a howling sowtd
may be produced. In this case, hold the microphone away
from the speakers, or decrease the microphone volume.
● If sound through the microphone is extremely loud, it may be
distorted. In thiS case, decrease the microphone volume.
19 ENGLISH
● When the function is changed, the microphone volume and,the
echo volume are set to off.
Recommended microphones
The use of unidirectional type microphones is recommended to
prevent howling. Coatact your local Aiwa dealer for details.
VOCAL FADEFUMULTIPLEX FUNCTIONS
This unit can use discs or tapes as Karaoke sources.
Press the KARAOKE button repeatedly to select the vocal
fader or multiplex function.
Use the vocal fader function for ordhary discs or tapes.
Use the multiplex function for multi audio discs or tapes.
?
Each time the KARAOKE button is pressed, one of these
functions is selected cyclically.
@
\@ @
.
@)Vocal Fader
The singer’s voice becomes softer than the accompaniment.
@ Auto Vocal Fader
The singer’s voice becomes softer only while there is audio
input through a microphone.
o Multiplex
Only. the sound on the left channel is heard from both
speakers, and the sound on the right channel is muted.
@ Auto Multiplex
The sound on the left channel is heard from both speakers,
and the sound on the right channel is muted only while there
is audio input through a microphone.
@ Cancel
To change the time lag setting in Auto Vocal Fader or
Auto Multiplex function
The muted original singer’s ‘voice can be turned faster to the
normal level.
When Auto Vocal Fader or Auto Multiplex is selected, “A-VF or
“AUTO MPX is displayed for 3 seconds and changes to the
selsected function name. After the selected function name is
displayed, hold down the KARAOKE button until FAST is
displayed,
To return to the initial setting, select SLOW.
When the power is turned off, SLOW is restored.
-,
To change the audible channel in Multiplex fun”ction
Only the sound on the right channel can be heard from both
speakers.
When Multiplex is selected,
“MPX L-ch” isdisplayed for 3 seconds
and changes to the selected function name. After the selected
function name is displayed, hold down the KARAOKE button
until MPX-R is displayed.
To return to the initial setting, select MPX-L.
When the power is turned off, MPX-L is restored.
m
● The Karaoke functions may not operate correctly with the
followina kinds of CDs or ta~es.
- Those-with monaural sound
- Those recorded with strong echoes
- Those with the vocal part recorded on the right or left side of
the sound width
● While the Karaoke function is on, the sound is output as
monaural.
● When the function is changed, the Karaoke function is canceled.