Agilent Technologies 83A Stereo System User Manual


 
Agilent N5161A/62A/81A/82A/83A MXG Signal Generators User’s Guide 265
Custom Digital Modulation (Option 431)
Using the Arbitrary Waveform Generator
Selecting the Filter
1. In the Setup Mod menu (page 263), press Filter > Select > Nyquist.
2. Press Return > Return.
Generating the Waveform
Press Digital Modulation Off On.
This generates a waveform with the custom, single–carrier NADC, digital modulation state created in
the previous sections. The display changes to Dig Mod Setup: NADC (Modified). During waveform
generation, the DIGMOD and I/Q annunciators appear and the custom single–carrier digital
modulation state is stored in volatile memory. The waveform is now modulating the RF carrier.
For instructions on storing this custom, single–carrier NADC, digital modulation state to the
non–volatile memory catalog, see Storing a Custom TDMA Digital Modulation State on page 265.
Configuring the RF Output
1. Set the RF output frequency to 835 MHz.
2. Set the output amplitude to 0 dBm.
3. Press RF On/Off.
The user–defined NADC signal is now available at the RF OUTPUT connector.
Storing a Custom TDMA Digital Modulation State
Using this procedure, you learn how to store a custom digital modulation state and a custom
multicarrier digital modulation state to non–volatile memory.
If you have not created a custom, single–carrier, digital modulation state, complete the steps in the
previous section, Creating a Custom TDMA Digital Modulation State on page 263.