Filter
Top Products
Bu t t o n S & Ja c k S
8
Turning the Headphones Off
Put the On/Off switch in the Off position. Don’t forget to unplug the
transmitter too!
To charge the headset unit:
1. Plug one end of the charging cable to
the Charge jack on the transmitter’s
back panel. (Make sure the
transmitter is plugged in!)
2. Plug the other end of the charging
cable into the Charge jack on the left
headphone.
While the headphones are charging, the
Charge indicator on the transmitter’s
front panel remains red. This LED turns
off when the headphones are fully
charged.
Charging the Headset
If you are using rechargeable batteries NiMH or NiCd (such as the
batteries provided), the batteries will charge when the headphones
are connected to the transmitter using the charging cable.
WARNING: To avoid risk of re or injury, DO NOT connect the
headphones to the transmitter with the charging cable if you installed
alkaline or other non-rechargeable batteries – this could cause the
batteries to leak, which would damage the headphones.
Transmitter
(back panel)
Left headphone
Charging
cable
Notes about charging:
• When the batteries are charged, remember to unplug the charging
cable from the headphones and transmitter.
• Never leave the batteries charging for more than 48 hours.
• The batteries should be charged for a full 8 hours.