Filter
Top Products
EN
9
Before you begin
2. Setup your AR Infinite Radio accounts
To simplify setup on the radio please complete these steps:
A. Find the Setup Information Card that contains your radio’s MAC address number (MAC: 00-21-2A-
XX-XX-XX) and activation PIN # (PIN: XXXX). (This number is also found in the Device Info screen
under the Settings menu in your radio.)
B. Using any Internet-connected computer, go to www.arinfiniteradio.com/setup and follow the
online instructions.
• You will need to input your radio’s MAC address and PIN # to associate your radio with your
personal settings.
3. Optional: Insert AAA batteries in the base of the radio
Follow the polarity markers in the battery compartment. The batteries power the clock and alarm*
whenever the radio loses electricity. We recommend that you replace the batteries every year (or
more often in case of multiple power outages) to avoid low battery power. Otherwise, clock and
alarm accuracy may be affected when electricity supply is interrupted.
4. For ARIRC205 only: Connect the AR Wi-Fi Enabler to your network
WA
N
L
A
N
res
e
t
po
wer
L
A
N
WAN
POWER
LAN
LAN
L
A
N
Broadband modem or
Ethernet router/hub/switch
• Make sure the power, WAN, and WIRELESS LEDs are on. The MODE LED state will vary depending
on your network configuration. If the MODE, WPS, and WIRELESS LEDs are blinking simultaneously,
this indicates a possible connection error. Please review your connections and then press and hold
the Enabler’s WPS button for 3 seconds (the MODE LED should start blinking) to rescan your
network configuration. The Enabler may restart multiple times during this process and take up to
two minutes depending on your network configuration. The MODE LED will stop blinking when
this process is completed. Go to www.arinfiniteradio.com for more information.
Electrical outlet
If your modem or router/hub/switch has only one LAN
port and is connected to your PC, disconnect the
Ethernet cable from the modem/router/hub/switch and
connect it to the Enabler's LAN port.
* When the battery backup functions, the clock display will not light. However, the function of alarm still occurs during the power
interruption if remaining battery power is adequate.