Filter
Top Products
29
EN
More information
Poor FM/AM Tuner reception.
• Check the antenna connection.
• Move antenna.
• Turn off nearby electrical appliances, such as
hair dryer, vacuum cleaner and microwave.
Cannot record radio.
• Record feature is only available for Internet
Radio, AM and FM Tuner.
• The internal memory of the radio may be full.
Remove some of the old recordings.
Cannot play back music files on connected
USB device.
• Make sure USB device is securely connected.
• Digital Right Management (DRM) type music
files will not be played.
• The radio supports FAT12, 16 and 32 file
systems only. Other file systems from Linux,
MAC or NTFS are not supported.
The LED of ON/STANDBY button is flashing.
• The LED is flashing (5-second interval) when
the unit is being powered by the backup
batteries due to electricity supply
interruption. Please check your AC power
supply.
• If the LED is flashing even faster (3-second
interval), this means that the unit is being
powered by weak backup batteries. Please
replace the backup batteries (refer to page
9). We recommend that you replace the
batteries every year (or more often in case of
multiple power outages) to avoid low battery
power. Otherwise, clock and alarm accuracy
may be affected when electricity supply is
interrupted.
Cannot stop the demonstration mode.
• To exit the demonstration, press and release
in sequence the buttons on top of the radio:
preset 1, then SLEEP/SNOOZE, then preset
6.
My question was not answered here.
• Visit www.arinfiniteradio.com for an up-to-
date list of frequently asked questions.
Further help on Wi-Fi Enabler (for
ARIRC205)
• The AR Wi-Fi Enabler adds Wi-Fi capability to
your existing network. Page 9, step 4 shows
you how to connect the AR Wi-Fi Enabler to
your network.
• Your Wi-Fi Enabler comes preconfigured from
the factory so normally no changes should
be necessary. This information is provided for
the more advanced users or for
troubleshooting purposes.
• If you encounter problems connecting the
radio to the Internet via AR Wi-Fi Enabler, the
settings on the radio may not match the
settings on the Enabler. Follow the steps
below to configure the settings again.
To find the configuration information of the
Wi-Fi Enabler:
• Find the Wi-Fi Enabler’s factory configuration
information on the white label on the back of
the AR Infinite Radio. This label includes: 1)
the Wireless Network’s name (SSID), 2) the
Security Type, and 3) the password/key.
To check if the configuration information is
the same in the radio:
1. Press
to display the Source menu of the
radio. Press to highlight Settings and then
press SELECT.
2. In the Settings menu, press to highlight
Network Setup and then press SELECT.
3. In the Network Setup screen, press to
highlight Wireless and then press SELECT.
4. At the warning screen, press SELECT while
Continue is highlighted in the screen below.