Filter
Top Products
3M™ Super Close Projection System SCP712 Operator’s Guide
© 3M 2008. All Rights Reserved. 15
Picture Menu
The Picture Menu, shown below, is used to adjust the picture settings to display the best possible image.
Feature Description Range Default
Picture
Mode
Select the best mode to optimize the projector image.
1. Max Brightness
2. Enhanced Photo
3. Photo
4. Enhanced
N/A
VGA-Max Brightness
Video-Enhanced Photo
Brightness Adjust brightness of displayed image 0–100 50
Contrast Adjust the contrast (dark to light) in the displayed image 0–100 50
Color
(see Note)
Adjust the intensity of color in the displayed image 0–100 50
Tint
(see Note)
Adjust the balance of red to green for video signals. -15–+15 0
Sharpness Adjust the displayed image to look sharper or softer -15–+15 0
Video
Noise
Reduction
Turn noise reduction ON or OFF N/A Off
Aspect
Ratio
Set aspect ratio to: [Full Screen or 16:9 or Native] N/A Full Screen
Advanced
This option only displays for Computer2/Component2
input and when I/O Module is connected. See next
page.
N/A N/A
Reset Reset values in Picture menu only N/A N/A
Picture Input Source: Computer 1
Picture Mode Enhanced Photo ►
Brightness 50 |···········●············|
Contrast 50 |···········●············|
Color 50 |···········●············|
Tint 0 |···········●············|
Sharpness 0 |···········●············|
Video Noise Reduction On
Aspect Ratio Full Screen
Advanced
Reset
Note: Tint/Hue can only be adjusted for S-Video and RCA video input signals