Broiler pan
and grid
Warm soapy water or a
soapy steel wool pad
l
Clean after each use.
l
Wash, rinse and dry well.
. Do not clean In Sell-Cleanlng Oven.
[See note on page 21.)
Oven racks Self-Cleaning cycle.
. Leave in oven during Self-Cleaning
cycle.
OR
Warm soapy water or 9 Wash, rinse and dry. Use soapy steel
soapy steel wool pads.
wool pads for heavily-soiled areas.
NOTE: The oven racks will discolor and be harder to slide when
left In the oven during the Self-Cleanlng cycle. If you want them to
stay shiny, remove from the oven and clean by hand. If racks are
left In the oven durtng the Self-Cleanlng cycle, apply a small
amount of vegetable oil to the sides of the racks to make them
easler to slide.
Oven door
glass
Spray glass cleaner or
. Make sure oven is cool.
warm soapy water and a
plastic scrubbing pad.
. Follow directions provided with
the cleaner.
. Wash, rinse and dry well.
Self-Cleaning
Oven
For areas outside the
Self-Cleaning area use
warm soapy water or
soapy steel wool pads.
. Follow directions starting on page
21, “Using the Self-Cleaning Cycle:’
. Do not use commercial oven
cleaners.
. Do not use foil to line the bottom
of your Self-Cleaning Oven.
The Oven Light
The oven light will come on when you open the oven door. To turn the light on
when the oven door is closed, push the Oven Light Switch on the control panel.
Push it again to turn off the light.
To ReDlace:
Electrlcal Shock and Personal Injury Hazard
l
Make sure oven and light bulb are cool and power to the oven has
been turned OFF before replaclng fhe Ilght bulb. Failure to do so could
result In electrloal shock or burns.
I
l
The bulb cover must be In place when using the oven. The cover
protects the bulb from breaking, and from hlgh oven temperatures.
Broken glass could cause injur$
I
. Unplug appliance or disconnect
at the main power supply.
!. Remove the bulb cover in the
back of the oven by pulling out
and pushing the wire holder to
the side.
continued on next page
25
