WINDING THE BOBBIN -2
C: Draw thread from the spool. Guide the thread around and under
the thread guide. Draw out the thread from the notch and pass it
under the disc.
1: Thread guide
2: Notch
3: Disc
4: Bobbin on Bobbin Winder Spindle
D: Push the Bobbin spindle to the left. Lead the thread through the hole
in the bobbin from the inside. Place the bobbin on the bobbin winder
spindle. Push the bobbin to the right.
E: With the free end of the thread held in your hand, depress the foot
switch. The motor will start and begin to wind the oibbin
After the bobbin has wound for about 10 seconds, stop the machine and
cut the thread close to the hole in the bobbin.
F: Depress the foot switch again. When the bobbin is fully wound, it stops
automatically. Return the bobbin winder to its original position by
moving the spindle to the left, and cut the thread.
C D
E F
Page 8
