IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, or injury to persons when using your appli
precautions, including the following:
•
Read all instructions before using the appliance.
•
Do not wash or dry articles that have been previously
cleaned washed or spotted with gasoline dry cleaning
solvents or other flammable or explosive substances as
at could ignite or explode.
•
Do not allow children to play on or in the appliance.
Close supervision of children is necessary.
•
Before the appliance is removed from service or
discarded remove the door to the washer
•
Do not reach into the appliance if the drum is moving.
•
Do not install or store this appliance where it will be
•
Do not tamper with controls.
•
Do not repair or replace any part of the appliance or
attempt any servicing unless specifically reco
maintenance instructions or in
repair instructions that you understand
and have the skills to carry out.
•
flammable or explosive substances to the wash water.
These substances give off vapors that could ignite or
•
Under certain conditions, Hydrogen gas may be
duced in a hot water system that has not been
used for 2 weeks or more. HYDROGEN GAS IS
EXPLOSIVE. If the hot water
used for such a period, before using this combination
dryer, turn on all hot water faucets and let t
water flow from each for several minutes. This will
release any accumulated Hydrogen Gas.
•
Do not use heat to dry articles co
or similar textured rubber
•
Keep the exhaust opening and surrounding areas free
from accumulation of lint, dust, and dirt.
•
The interior of the machine should be cleaned period
cally by qualified service personnel.
•
Do not place items exposed to cooking oil in your
dryer. Items contaminated with cooking oils may
contribute to a chemical reaction that could cause a
•
ean drain filter assembly at front of machine
You should carefully position the drain hose to avoid
kinks and ensure proper drainage of the water. Use
drain loop or suitable clamp to support drain hose at
25" (62 cm) minimum 34" (86 cm) maximum. The outlet
e must be at least 20" (50 cm) above
the base of the machine. Entry into sink drain system
must be above trap. When routing the
cabinets or walls assure no ruff or sharp edges can
age the drain hose. All sharp edges
ered by a protective material such as electrical or duct
tape. Use a drain hose clamp to secure drain hose to
•
You may connect directly to a "Wye" Branch Tailpiece
available at most hardware stores.
•
You may connect directly to a Disposer
the manufacturer attachment method.
•
You may connect directly through the floor to a
rate trap. The trap must be vented to prevent
siphoning. To provide proper venting; install an Air
Gap Kit available at most
•
You may connect to the manufacturers sink drain kit
(sold separately) that will supply water from your
faucet and discharge water directly into your sink.
