The straight end of these hoses should be connected to
the supply (Fig. 4). The 90° angled end of these h
should be connected to the inlet valves on the back of
the machine, using one of the washers to make a water
each connection. The couplings should be
tightened by hand, a tool should only be used if a leak
The Inlet valves are color
It is possible to run the machine on cold wate
but a water supply must be connected to each inlet
valve. To do this we suggest you use "F" connector,
Make sure the drain hose is not kinked and the water
andpipe installation is used it must be at least
" (3.2 cm) in diameter with a minimum carry away
Wall or Floor Standpipe Drain:
Top of standpipe must be at least 25" (62 cm) high and no
(86 cm) from bottom of washer (A & B).
This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the ris
shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having
grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is
alled and grounded in accordance with all local codes and ordinances.
Improper connection of the equipment
onductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in doubt as to whet
her the appliance is properly grounded.
Do not modify the plug provided with the appliance.
If it will not fit the outlet, have
a proper outlet installed by a qualified electrician.
You should carefully position the drain hose to avoid
kinks and ensure proper drainage of the water.
outlet end of the drain hose must be at least
20" (50 cm) above the base of the machine. At this
point it is possible for the w
ater to be discharged into
a sink, standpipe or drainpipe.
No more than 6" of the drain hose should insert into a
ssure an air break is available to prevent
the machine from siphoning in a standpipe.
