SETTING THE CLOCK
1
2
3
/- —.. —
—
-.
Ju
/
,--——
—
/1 (
Press the CLOCK button on the remote control,
and press the II SET button within 4 seconds.
Press the <+ DOWN or F- UP button to
designate the hour, and press the II SET button.
The hour stops flashing and the minute starts flashing.
Press the ++ DOWN or ➤ F UP button to
designate the minute, and press the II SET
button.
The minute stops flashing on the display and the clock stark
from 00 seconds.
To display the current time
Press the CLOCK button on the remote control. The time is
displayed for 4 seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button on the remote control and then press
the
■ button within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
[f the clock display flashes
This is caused by a power interruption. The current time needs
to be reset,
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
SETTING THE TIMER
1
2,4
6
3
1,2
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
Use the remote control.
1
2
3
4
Press the TIMER button repeatedly until @
appears on the display , and press the II SET
button within 4 seconds.
O is
displayed, and the hour flashes
m
If you press the II SET button after 4 seconds,
operation may start.
another
Designate the hour of the timer-on time by
pressing the l<< DOWN or ➤I UP button, and
press the 11 SET button. Repeat to designate the
minute of the timer-on time.
After you designate the timer-on time, one of the source name
flashes on the display for 4 seconds.
Within 4 seconds, press one of the function
buttons to select a source.
The selected source name flashes for 4 seconds. At this time,
the selected function button does not light up.
● If this step is not completed within 4 seconds, repeat from
step 1.
● If the TUNER button is pressed, the band cannot be selected
in this step.
Within 4 seconds, select the duration for the
timer-activated period with the l<< DOWN or WI
UP button.
21 ENGLISH
