MUSIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
Press the 41-4 or
➤> button during playback referring to the
playback side indicator (< or -) on the display.
For example, when the
➤* button is pressed while > is
displayed, playback of the next track starts.
Music sensor function may not be able to detect tracks under
the following conditions:
● Blanks of less than 4 seconds between tracks
● Noisy blanks
● Long passages of low-end sound
● Low overall recording levels
CONTINUOUS PLAY
I
3 h“ ---
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press the TAPE/DECKl/2 button to select the
deck to be played back first.
Press the REV MODE button to select Z).
Press the 4> button to start playback.
Playback continues until the ■ button is pressed.
About cassette tapes
● To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Type 11tape
Tab for side A
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type 11 tapes, take care not to
cover the Type 11tape detection slot.)
● 120-minute or longer tapes are extremely thinand easily
deformed or damaged, They are not recommended.
● Take up any slack in the tape witha pencil or similartool
before use. Slacktape may break orjam inthe mechanism.
\
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system.
ENGL/S/+
1~!
