40
DCR-PC7E 3-858-632-12E (E32)
Returning to a pre-registered position
Using the Remote Commander, you can easily go back to the desired point on a tape
after playback.
(1) During playback, press ZERO SET MEMORY at the point you later want to
locate. The counter shows “0:00:00” and “ZERO SET MEMORY” appears on
the LCD screen or in the viewfinder.
(2) Press p when you want to stop playback.
(3) Press 0 to rewind or press ) to fast-forward the tape to the counter’s zero
point. The tape stops automatically when the counter reaches approximately
zero. “ZERO SET MEMORY” disappears and the time code appears.
(4) Press ·.
Notes on the tape counter
There may be a discrepancy of several seconds from the actual time or time code.
Notes on ZERO SET MEMORY
• When you press ZERO SET MEMORY, the counter’s zero point is memorized. Press
ZERO SET MEMORY again before step 3 to cancel the memory .
• Zero set memory may not function when there is a blank portion between pictures on
a tape.
• Zero set memory functions in recording standby mode.
0:00:00
ZERO SET
MEMORY
STOP
0:12:34
ZERO SET
MEMORY
1
24
PLAY
REW
3
FF
