SETTING UP
REMOTE CONTROL(S)
This
procedure
initializes each Re-
mote Control so that the Console rec-
ognizes its commands.
HT544
Remote Control
1.
2.
3.
4.
Install a 9V
alkaline
battery in the
HT544’s
battery compartment.
Set the Console to INSTALL.
Press
[ARM]
on the
HT544.
The Console emits a tone. If you do
not hear a tone, press the
HT544’s
[CODE] button with a pencil.
Then, repeat this step.
To set up additional
HT544s
(up to
eight), repeat steps l-3.
Note: when you set the Console back
to RUN it plays back the stored mes-
sage and the BUSY light stays on for
15 seconds.
6
nonrto
Contrrl
HT544
KF574 Key Chain Remote Control
1.
2.
3.
4.
Install a 6V alkaline battery inside
the
KF574.
Use Eveready
A544,
Radio Shack
23-469,
or equivalent.
Set the Console’s slide switch to
INSTALL.
Press [ARM] on the
KF574.
The Console emits a tone. If you do
not hear a tone, press
the
KF574’s
[CODE] button with a pencil.
Then, repeat this step.
To set up additional
KF574s
(up to
eight), repeat steps l-3.
When you set the Console back to
RUN it plays back the stored message
and the BUSY light stays on for 15
seconds.
Note: you can install any combination
of Remote Control types (HT544,
KF574 or SH624) up to a total of eight
Remote Controls. For example: you
could install two
HT544s.
two
SH624s
and four
KF574s.
or any other combi-
nation up to a total of eight Remote
Controls.
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com
