SETTING UP AND USING MOTION DETECTORS
This procedure initializes each Motion
Detector so that the Console recogniz-
es it. You install a Motion Detector
just like you install Door/Window
Sensors. Each Motion Detector will be
assigned to one of the 16 zones.
1.
2.
3.
4.
5.
6.
7.
Install a
9-volt
alkaline
battery in
the battery compartment on the
front of the Motion Detector.
Set the Console’s slide switch to
INSTALL.
Press [CODE] on the back of the
Motion Detector with a pencil.
Press [TEST] on the back of the
Motion Detector. The Console’s
next unused zone indicator lights
and
the Console sounds a tone to
indicate that the receiver accepted
the Motion Detector.
Place one of the enclosed num-
bered stickers on the Motion Detec-
tor to show its zone number.
To set
up
additional Motion Detec-
tors, (up to 16 zones) repeat Steps
l-5.
Set Console to RUN (BUSY light
stays
on for 15 seconds).
Home/
Away
1
1
OFF
2
USING THE
SP554A.
Set switch on left (looking at back) to
(1) to trip
alarm
if ANY movement is
detected (most sensitive). Set switch to
(2) to trip alarm if two movements de-
tected or continuous movement detect-
edin a short time (less sensitive to pets).
Using
SPS54A
with SH624:
Set switch on right to Home/Away.
Use the SH624 Remote Control to arm
the system in the Away mode (which
arms Door/Window Sensors AND
SP554As)
or in the Home mode (which
arms Door/window Sensors only).
Using
SPSS4A
with
HT544/KF574:
Set switch on right to NORMAL and
switch on left to (1) or (2) to include
SP554A
when arming system. Set
switch on left to OFF if you don’t want
it to arm (i.e. when you’re at home).
Testing the
SPS54A
Place
SP554A
within
100
feet of Con-
sole. Walk past
SP554A.
Console
chimes. Wait 20 seconds before re-
peating test (the
SP554A
has a 20-sec-
ond lock-out to extend battery life).
Arm system,
walk
past
SP554A:
alarm
trips. Press [DISARM] on Remote.
0
Slide battery compartment down to open
1
OFF
2
TQT
0
Home/
Away
N
0
4
L
a
1
11
Smarthome.com, Inc. (800) SMART-HOME (949) 221-9200 http://smarthome.com
