IOTOF
ELECTRICAL REQUIREM E
UNPACKING AND CHECKING
ASSEMBLY
Mounting Belt and Disc Sander
N.........: 2
........ _5
MTENTS . :::... 6
To Workbench ............................... 7
Clamping Belt And Disc Sander
To Workbench ............................... 7
installing Timing Belt .......................... 8
installing Pulley Cover ......................... 9
installing Sanding Disc Plate .................. 9
Installing Backstop ............................ 10
Installing Table Assembly .................... 10
:Squaring Table::_sSembly:, ......... ........... 11
ReP!aci_g_The:i:::Sanding:Belt : :::
AND
: DISC SANDER: :::;: ::::; :::, ::.: ... ..... ;,.. 13
Positioning Beii Table... : ::.. ........ : .... ,.. 15
Belt Table Stop:. : ::.. ......... ! .... ;. i ....... 16
Surface Sanding On
Sanding Belt ................................ 16
End Sanding On The
Sanding Belt ................................ 16
Sanding Curved Edges ....................... 17
MAINTENANCE .............................. 18
Lubrication .................................. 18
TROUBLESHOOTING ........................ 19
RECOMMENDED ACCESSORIES ............. 19
REPAIR PARTS .............................. 20
unpacking and checking
TOOLS NEEDED
A
B
contents
Model 113.226424 Bert and Disc Sander is shipped
complete in one carton.
Separate all parts from packing materials and
check each item with illustration and "Table of
Loose Parts." Make certain all items are accour'_ _
ed for, before discarding any packing material.
If any parts are missing, do not attempt to
assemble the Belt and Disc Sander, plug in the
power cord, or turn the switch on until the miss-
ing parts are obtained and installed correctly.
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET
UNTIL ALL ASSEMBLY STEPS ARE COMPLETE
AND UNTIL YOU HAVE READ AND UNDER-
STOOD THE ENTIRE OWNERS MANUAL.
ITEM TABLE OF LOOSE PARTS QTY.
A Belt and Disc Sander Assembly .,.
8 Owner's Manual ...............
C Table Assembly ................
D Sanding Plate .................
E Sanding Disc ..................
F Table Support Rod .............
G Bag Assembly Part #507771 .....
Containing the following parts:
Clamp-Bolt ....................
Switch, Key ...................
Screw Soc. Set 5116-24X318 ......
Wrench, Hex "L" 118 ............
Backstop .....................
Washer, 114" . .................
: :: I Bolt, Flex I14-20X112 ............
Setscrew I14-20XI14" . ..........
• Screw 114-20X1-3!4" . ...........
Lockwasher 1/4" , .............. ,
: D : : : ' _F: " : H Pulley Cover ,,.................
:: :: :: : : : ::::: :::: : : :::::::: :::_::::::::: G: 6 J : TimngBelt ................... I
1
1
1
t
1
1
1
1
1
!
1
1
1
1
1
1
1
1
