,_NDING CURVED EDGES
!! !
....CURVED EDGES
Always sand inside curves on the idler pulley as shown.
WARNING: NEVER ATTEMPT TO SAND THE ENDS
OF A WORKPIECE ON THE IDLER PULLEY. APPLY-
ING THE END OF THE WORKPIECE TO THE IDLER
PULLEY COULD CAUSE IT TO FLY UP AND
RESULT IN AN INJURY,
Always sand outside curves on the left side of center
on the sanding disc as shown.
WARNING: APPLYING THE WORKPIECE TO THE
RIGHT SIDE OF THE DISC COULD CAUSE tT TO
FLY UP (KICKBACK) AND RESULT IN AN INJURY.
SANDING SMALL END SURFACES ON THE
SANDING DISC
Always move the work across left side of center on the
sanding disc face as shown.
WARNING: APPLYING THE WORKPIECE TO THE
RIGHT SIDE OF THE DISC COULD CAUSE IT TO
FLY UP (KICKBACK) AND RESULT IN AN INJURY.
MITER GtJAGE :ENTER
(ACCESSORY
NOTE: Use a combination square to square the miter
gauge to the face of the disc (combination square must
be "irue" -- See Start of Assembly section on page 6
for checking method). If it is not square, loosen the
miter gauge knob and move the miter gauge slightly
,_/kntil it is square. Without moving the miter gauge,
° )hten the knob securely.
i1,1 ,i,,,..................._ [_
COMBINATION _SOUARE
17
