4. Slide table assembly onto rod.
WARNING: TO AVOID TRAPPING THE WORK
OR FINGERS BETWEEN THE TABLE AND SAND-
ING SURFACE, THE TABLE EDGE SHOULD BE A
MAXIMUM OF 1/16-INCH FROM SANDING SUR-
FACE. TABLE ASSEMBLY SHOULD BE COM-
PLETELY ENGAGED ON ROD.
I
ROD SET
SCaEW
,
6.
Install and tighten set screw with Alien (Hex)
wrench.
There is an auxiliary mounting hole in the
base. This is for mounting the table when the
belt is used in a vertical position by moving
the complete rodlworktable assembly and
toggle bolt. Note and follow the above
WARNING for table clearance.
AUXILLARY
r_OUNfl_NG
HOLE
SETSCREW
............. iiiiiiii
SQUARING TABLE ASSEMBLY
WARNING: TO AVOID INJURY FROM AC-
CIDENTAL START, MAKE SURE TOOL IS UN-
PLUGGED BEFORE ALIGNING.
1. Using a combination square, check the angle
of the worktable with the disc.
NOTE: The combination square must be "true"
-- See start of assembly section on Pg. 6 for
checking method.
2. If the table is not 90 ° with the disc.., loosen
table lock knob screw and tilt table.
3. Adjust worktable square to the disc and re-
tighten table lock knob.
Adjust pointer to 0 ° mark on trunnion with
phillips screwdriver if necessary.
TOGGLE
BOLT
11
