Changing Formats and Supplies
While in Data Entry mode, you may use several different
formats to enter batch data. These formats may require a
different supply size. See your management for a list of the
formats and the required supply sizes.
The supply size loaded in the printer and the supply size
required by the format must match. If the supply loaded is
not what the format requires, a message will tell you to check
the supply. The printer will not print the new batches until you
load the correct supply.
When you switch to a format that requires loading a new
supply, DO NOT turn the printer off. Use this same procedure,
regardless of the supply size you’re using.
1. Load the new supply. See "Changing Supplies" in the
Equipment Manual
.
2. Select the new format.
3. Press to align the supply.
4. Enter a batch.
If the printing is not aligned properly on the supply, you can
realign it. To do this:
1. From the main menu select Printer Options and press
. You’ll see
Select Printer Option: ↓
Use Batch Separators __
Using Data Entry
2. Using Data Entry
2-15
