5: Commands and Levels
XPort Pro Command Reference 104
A decimal value character has the form \99.
A hex value character has the form 0xFF.
link (config-ethernet:eth0) level commands
Restores the default duplex setting, which is auto.
Restores the default speed setting, which is auto-
negotiate.
Sets duplex mode to auto.
Sets duplex mode to full.
Sets duplex mode to half.
Exit back to interface configuration level
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Sets the speed of the Ethernet link to 10 Mbps.
Sets the speed of the Ethernet link to 100 Mbps.
Sets the speed of the Ethernet link to auto-negotiate.
Stores the current configuration in permanent memory.
log (config-diagnostics-log) level commands
Restores the factory default maximum Log file size.
Exits to the next higher level.
Sets the maximum size in Kbytes for the Log file.
Enables log to filesystem.
Enables log to serial line.
Could not find VarID 438 entry 3 in file
http/config/varid_help.mtxt
Log only Error and more severe events.
severity level information
Log only Information and more severe events.
Log only Notice and more severe events.
Log only Warning and more severe events.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
Continuously displays lpd status for the specified line.
<line> = LPD line to display.
Exits to the enable level.
Kills the current print job on the specified line.
<line> = LPD line with print job.
show <line>
Displays lpd status for the specified line.
<line> = LPD line to display.
Displays the last 20 commands entered during the current
