ENGINE RIGHT SIDE 5-9
Right Engine Cover
Right Engine Cover Disassembly
•
Remove the right engine cover (see this chapter).
•
Pull out the clutch release shaft [A].
CAUTION
Do not remove the clutch release shaft unless it is
absolutely necessary. If removed, you must replace
the oil seal with a new ones.
•
Refer to the cooling system chapter for water pump seal
and water pump bearing removal.
Right Engine Cover Assembly
•
When the oil level gauge, needle bearings and oil seal
were removed, note the following .
○
Set the new oil level gauge [A] so that its metal portion [B]
faces outward and press in the gauge until it is bottomed.
○
Press the new lower needle bearing [C] until it is bot-
tomed. As for the installation direction, both sides are
available.
○
Set the new upper needle bearing [D] with the marked
side facing out and press bearing until it is bottomed.
○
Press the new oil seals [E] until they are bottomed and
apply a little high temperature grease [F] on the rips.
•
Refer to the Cooling System chapter for water pump seal
and water pump bearing installation.
