49
9
CONNECTIONS AND MAINTENANCE
New2001
9
■ MB-75 installation
An optional MB-75
FLUSH MOUNT KIT
is available for mounting
the transceiver to a flat surface such as an instrument panel.
CAUTION: KEEP the transceiver and microphone at least
1 meter away from your vessel’s magnetic navigation com-
pass.
q Using the attached template, carefully cut a hole into the
instrument panel (or wherever you plan to mount the trans-
ceiver).
w Slide the transceiver through the hole as shown below.
e Attach the 2 supplied bolts (M5 × 8 mm) on either side of
the IC-M603.
r Attach the clamps on either side of the IC-M603.
• Make sure that the clamps align parallel to the IC-M603’s body.
t Tighten the end bolts on the clamps (rotate clockwise) so
that the clamps press firmly against the inside of the in-
strument control panel.
y Tighten the locking nuts (rotate counterclockwise) so that
the IC-M603 is securely mounted in position as below.
u Connect the antenna and power cable, then return the in-
strument control panel to its original place.
!IC-M603.qxd 06.7.28 1:46 PM Page 49 (1,1)
