10
3 BASIC OPERATION
New2001
■ Call channel programming
You can program the call channel with your most often-used
channels in each channel group for quick recall.
q While pushing and holding [H/L], push [DIAL] several
times to select the desired channel group (INT, USA, ATIS
or DSC) to be programmed.
w Push and hold [!6•C] for 1 sec. to select the call channel of
the selected channel group.
•“
CCAALLLL
” and call channel number appear.
e Push and hold [!6•C] again
for 3 sec. (until a long beep
changes to 2 short beeps)
to enter call channel pro-
gramming condition.
• Channel number starts blink-
ing.
r Rotate [SELECTOR] to se-
lect the desired channel.
t Push [!6•C] to program the
displayed channel as the
call channel.
• Push [CLR] to cancel.
• The channel number stops
blinking.
■ Microphone lock function
The Microphone lock function electrically locks [Y]/[Z] and
[HI/LO] keys on the supplied microphone. This prevents ac-
cidental channel changes and function access.
➥ While pushing and holding [HI/LO] on the microphone,
turn power ON to toggle the Microphone lock function ON
and OFF.
■ Display backlight
The function display and keys can be backlit for better visibil-
ity under low light conditions.
➥ After pushing [F], push [3• ] then rotate [SELECTOR]
to adjust the brightness of the LCD and key backlight.
Then push [ENT].
• The backlight is adjustable in 7 levels and OFF.
DIM
25W25W INTINT CALLCALL
TAGTAG
3434°34.506N34.506N
123123°23.236W23.236W
UTCUTC 1212:00:00 CALLINGCALLING
25W25W INTINT CALLCALL
DUPDUP
TAGTAG
3434°34.506N34.506N
123123°23.236W23.236W
UTCUTC 1212:00:00 INTLINTL
!IC-M603.qxd 06.7.28 1:46 PM Page 10 (1,1)
