Version 1.2 Page 11 4/22/04
Powering System On/Off from the BMC
To power a system on, enter the following commands:
<ESC>(
cli>p 1
System Power set to ON
To power the system off, enter the following commands:
<ESC>(
cli>P 0
System Power set to OFF
Booting OpenVMS from the BMC
Step 1 Get the consoles attention by entering <ECS>(
<ESC>(
cli>
Step 2 Power the system on.
cli>p 1
System Power set to ON
cli>
Step 3 Exit console mode <ESC>Q, and wait for the EFI command menu. (Note that some
systems may have been set to time out after a small number of seconds.) You see the
Shell> prompt.
EFI Boot Manager ver 1.10 [14.61] Firmware ver 2.20 [4331]
Please select a boot option
EFI Shell [Built-in]
Boot Option Maintenance Menu
System Configuration Menu
Use ^ and v to change option(s). Use Enter to select an option
Step 4 Use "v", or "^", ! " to select the "EFI Shell [Built-in]". You then get the Shell>
prompt:
Loading.: EFI Shell [Built-in]
EFI Shell version 1.10 [14.61]
Device mapping table
fs0 : Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun0,Lun0)/HD(Part1,SigC1CEDDA4)
blk0 : Acpi(HWP0002,0)/Pci(2|0)/Ata(Primary,Master)
blk1 : Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun0,Lun0)
blk2 : Acpi(HWP0002,100)/Pci(1|0)/Scsi(Pun0,Lun0)/HD(Part1,SigC1CEDDA4)
Shell>
